Bona R860 is a silane-based construction adhesive that can be used for all general applications such as fixing hollow spots, skirting boards and stair treads etc.

Bona R860 is a silane-based construction adhesive that can be used for all general applications such as fixing hollow spots, skirting boards and stair treads etc.

Bona R880 is a silane-based construction adhesive that can be used for all general applications such as fixing hollow spots, skirting boards and stair treads etc.

7kg (2-component with water satchet)

A unique, single coat, fast setting, silane-based moisture barrier. Water and solvent-free, Bona R580 is designed to treat damp sub floors prior to the installation of wood flooring using Bona silane-based adhesives. Bona R580 can be used as a 2-component system with water to gain an even shorter setting time. Easy trowel application.

Bona R580 is also compatible with Bona H650 levelling compound. Quartz sand must be broadcast into wet Bona R580 before the application of the levelling compound.

Bona R580 is fully compatible with Bona adhesives R850, R845 and R860 which can be applied directly to the moisture barrier.

NOTE: Bona R580 cannot be used where bitumen is present.

A unique, single coat, fast setting, silane-based moisture barrier. Water and solvent-free, Bona R580 is designed to treat damp sub floors prior to the installation of wood flooring using Bona silane-based adhesives. Bona R580 can be used as a 2-component system with water to gain an even shorter setting time. Easy trowel application.

Bona R580 is also compatible with Bona H650 levelling compound. Quartz sand must be broadcast into wet Bona R580 before the application of the levelling compound.

Bona R580 is fully compatible with Bona adhesives R850, R845 and R860 which can be applied directly to the moisture barrier.

NOTE: Bona R580 cannot be used where bitumen is present.

Bona H650 is a rapid drying and hardening self-levelling and smoothing compound specifically designed for areas where speed is essential for rapid renovation and repair work prior to using Bona R850. It has ultra rapid drying properties and can be covered after approximately 1.5hrs

For thickness greater than 5mm, additional time should be allowed

If other adhesives are used, the minimum drying time is 24hrs

Bona D550 is a one-component dispersion-based primer for the preparation of substrates prior to the use of Bona H650 self-levelling compound. It is recommended for use on Calcium Sulphate screed, chipboard and cement based substrates.

Bona D500 is a waterborne primer designed for the preparation of substrates prior to the application of adhesive. The substrate is improved by binding residual dust and reducing the absorbency of the subflooor, therefore aiding adhesive application. D500 must be diluted 1:1 with water prior to application by brush or roller.

NOTE: If Bona R850 adhesive is to be used, Bona R410 should be used instead of Bona D500.

A solvent and water free, two-component epoxy resin, suitable for damp proofing concrete or sand/cement subfloors, or for use as a primer prior to the application of a suitable adhesive or levelling compound. R410 can be used in conjunction with Bona R770 and R850 without additional preparation of the subfloor. For damp proofing concerete (sand/cement screeds) up to 5% moisture (CM) or 98% (R.H.), a two coat system is required. Application should be made with brush ort roller. Bona adhesives R845 and R860 can also be applied directly to Bona R410.

NOTE: When used as a primer, a single coat should be applied. When used as a DPM, two coats should be applied.

Recoat time: 2-3hrs.

A two-component, polyurethane adhesive for the installation of wooden flooring. R770 is free from water and organic solvents and is ideal for moisture sensitive timber species. This versatile adhesive can be used on many different types of substrate (including non-absorbent) including: concrete floors, plywood and chipboard, cementitious screeds, anhydrite screeds, levelling compounds (at least 2mm thick), mastic asphalt and non absorbent surfaces such as ceramic tiles, metal etc and floors trated with Bona R410 liquid damp proof membrane.

A two-component, polyurethane adhesive for the installation of wooden flooring. R770 is free from water and organic solvents and is ideal for moisture sensitive timber species. This versatile adhesive can be used on many different types of substrate (including non-absorbent) including: concrete floors, plywood and chipboard, cementitious screeds, anhydrite screeds, levelling compounds (at least 2mm thick), mastic asphalt and non absorbent surfaces such as ceramic tiles, metal etc and floors trated with Bona R410 liquid damp proof membrane.

H790 is a two-component dispersion parquet adhesive which conforms to DIN 281. Immediately after mixing component A (Dispersion) and component B (Powder) a chemical reaction starts. This chemically binds more that 50% of the total water content within the product in approximately four hours. The ratio of free water in the adhesive is less than 11%. It is especially suitable for timbers sensitive to swelling and for low absorbent substrates.

• No solvents therefore no health & safety implications
• Very low water content (11%)
• Minimal swelling of the timber
• High level of adhesion soon after application

Application: The two components must be thoroughly mixed using a drill fitted with a mixing blade. Mix until a uniform colour is achieved. Application should be made using a notched trowel of an appropriate size. Application should be made to an area no larger than that which can be laid within 10 minutes. The flooring should be laid onth eadhesive and pressed gently into the surface.

Coverage: Depends upon size and type of flooring. It is important that correct rates are used to avoid problems associated with poor adhesion - 1,000 g/M squared - 10mm solid parkett, 22mm strip flooring, 2 layer prefinished parkett

ADVANTAGES

• H790 is not suitable for bitumen backed blocks, finger mosaic etc.
• Drying time/cure time may be affected by adverse site conditions such as low temperature and high humidity
• It is recommended that the substrate be primed using Bona D500
• H790 conforms to DIN 821
• Suitable for use with under floor heating

Wakol D1680 is a dispersion-based adhesive for laying mosaic parquet, vertical lamella parquet, strip parquet, 10 mm solid parquet in oak as well as 2- and 3-layer ready-to-lay parquet and wood blocks, type RE/WE on absorbent subfloors indoors.

This is a fast-setting, solvent-free adhesive characterized by high bonding strength that meets the rigorous requirements of DIN 14293 and EMICODE EC1 for very low emissions.

PU-210 is a 2-component adhesive for shear-resistant laying of solid parquet, mosaic, strip, on edge lamella and ready-to-lay parquet, exotic parquet, wood block RE as well for approved stratifie flooring on absorbent and non-absorbent subfloors that corresponds to EN 14293.

PU-210 is a 2-component adhesive for shear-resistant laying of solid parquet, mosaic, strip, on edge lamella and ready-to-lay parquet, exotic parquet, wood block RE as well for approved stratifie flooring on absorbent and non-absorbent subfloors that corresponds to EN 14293.

Glue Screws is a high strength, quick grab, solvent-free Bonding Adhesive with gap filling properties that adheres to virtually all common building materials and replaces nails and screws in a multitude of applications.

We supply this product for fixing our light weight ceiling roses, light weight resin coving, and light weight composite coving. It also bonds all common construction materials including brick, timber, concrete, stone, ceramic, plaster, metal, plastic, marble, brick veneer and insulating materials.

Recommended for fixing skirting boards, decorative wall panelling, door surrounds, timber and PVCu cladding, floor boards, timber framework, worktops, floor grippers and metal edges, carpet, brick veneer, mouldings, ceramics, plasterboard, cork, laminates and automotive trims. Eliminates squeaks on floors and stairs, and much more. Can be used on rough or smooth surfaces, inside or out.

Do not use in areas subject to continuous water immersion, with bitumen or asphalt.

Available in 300ml cartridges Colour: White.

R850 is an elastic 1-component silane-based adhesive for parquet floors. The hardened adhesive is similar to conventional adhesives - able to withhold thrust during expansion, while the resistance sgainst shrinkage is very low. Tensions to the sub floor are therefore reduced. The use of a primer is in general not necessary. The adhesive hardens by a chemical reaction with moisture.

• 1-component, easy to handle
• soft elastic
• water and solvent free, nearly no swelling of the wood
• good adhesion to almost all substrates and timber materials, splashed material can be easily removed
• firm fixture - retains trowel pattern

R850 is an elastic 1-component silane-based adhesive for parquet floors. The hardened adhesive is similar to conventional adhesives - able to withhold thrust during expansion, while the resistance sgainst shrinkage is very low. Tensions to the sub floor are therefore reduced. The use of a primer is in general not necessary. The adhesive hardens by a chemical reaction with moisture.

• 1-component, easy to handle
• soft elastic
• water and solvent free, nearly no swelling of the wood
• good adhesion to almost all substrates and timber materials, splashed material can be easily removed
• firm fixture - retains trowel pattern